CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
MPLAB7.51 build failure

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jaymiller
Guest
MPLAB7.51 build failure
PostPosted: Fri Jan 26, 2007 8:36 pm     Reply with quote
Ok, so I decide to 'upgrade' to MPLAB 7.51 from 4.99 and the install is ok. creating asm code works...Download and install the CCS 'magic program' to allow MPLAB to see my PCM ( Version 2.624). It kinda works but erros out as a 'build failure'.I'm not impressed,mega power program craps out without a hint of WHY! I can import the .hex file that MP4.99 creates before it dies(white screen close-ignore)(that's why I 'upgraded...') and MP7.51 will program the chip just fine,dissemble,etc.
Any ideas what's going on??? Yes I know V2.624 is old but then so am I, and it has worked for me for years.
Thanks for any help.
Jay in snowy Greensville,Ontario
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Fri Jan 26, 2007 9:03 pm     Reply with quote
Quote:
Yes I know V2.624 is old.

I don't think a compiler version that old will work with the modern MPLAB.
It should work OK with vs. 5.70.40. I tested PCM vs. 2.674 with that
version just now and it worked OK. It doesn't support colored syntax
but at least it works.
Here's a link to the MPLAB archives:
http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en023073
jaymiller
Guest
mplab
PostPosted: Sat Jan 27, 2007 6:57 am     Reply with quote
Hello again PCM programmer.Ok,I've 'uninstalled MPLAB7.51,7.50 and 5.7'. Installed 5.7 again. My PCM is in c:\PICC. When I try to build I get the error 'Selectcted Build Tool not correctly installed'. I did run from DOS, ccsc.exe -setup.thinking that would be the cure'. Same message.
I need just a bit more help...arrgh, and another coffee !
Thanks at least 5.7 doesn't crash.
Jay
jaymiller
Guest
mplab....
PostPosted: Sat Jan 27, 2007 8:27 am     Reply with quote
OK, finally got it to work! Had to go int the Edit project>Node Properies>select PCM.
Now it Builds(compiles) OK.
arrrghhhh......

Thanks PCMprogrammer,I'll stick with MPLAB5.7...now that both ASM and C are working.

Jay in snowy Greensville,Ontario
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group