The microchip ICD2 can supply 5V to the target circuit, can the ICD-U40 do the same? I did not see anything in the ICD software to enable/disable 5V to the target.
If not can it be modified (software/hardware) to provide this functionality?
This ICD unit connects to the PC and the debugging software over USB (USB cable included). The ICD-U40 Unit is powered from the USB bus. It can also power a board @5V by closing the jumper near the ICD jack inside the unit (the unit must be opened).
ktallevi
Joined: 17 Dec 2005 Posts: 58
Posted: Thu Mar 13, 2008 12:58 pm
thanks guys, it works. Not sure how I missed that, its clearly documented :)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum