CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ICD-U40: 47k on MCLR?

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
rooney



Joined: 28 Aug 2004
Posts: 8

View user's profile Send private message

ICD-U40: 47k on MCLR?
PostPosted: Tue Feb 21, 2006 12:59 am     Reply with quote
I've to confess I'm not the best hardware engineer so I'm a little bit confused what for the 47k resistor on MCLR is required. Well I know that it is used for pulling up the signal zu VDD (5V) but during the programming process it will be pulled to 13V. In my application VDD of the controller is not isolated during programming, so other ICs are all connected to VDD, any time.
If the PIC is in programming state, what will happen to my 5V supply? Will my ICs be shortly powered by 13V?
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue Feb 21, 2006 1:29 am     Reply with quote
See this thread:
http://www.ccsinfo.com/forum/viewtopic.php?t=22532
rooney



Joined: 28 Aug 2004
Posts: 8

View user's profile Send private message

PostPosted: Wed Feb 22, 2006 12:03 am     Reply with quote
Thanks a lot, question fully answered.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group