ERROR (drives crazy) ---> Expecting a close paren

[PravinP]

Dear Members,
I am using PIC10F200

i have the following definition in my file
#define ENABLE PIN_B0

when i compile the code with
if(input(ENABLE))
{
output_high(ENABLE);
break;
}

i get error message "Expecting a close paren"

Its really driving me crazy because i cannot read my input port pin. I have even tried using if(input(PIN_B0)), but still the same error.

Please share ur views on whats going wrong

Pravin

[Guest]

Try to use another word in place of ENABLE.

[Humberto]

Do not know what do you try to do with:

[PravinP]

Hi,
sorry made some errors while posting the code
The define file is

#define ENB PIN_B0
#define INP PIN_B3

while(1)
{
delay_ms(DELAY);
if(input(INP))
{
output_high(ENB);
break;
}

-----
--
--
}

while(1);

I am scanning the port pin PIN_B3 for high, if i sense a high on the pin, i exit the loop
But i get the same error "Expecting a close paren" after i compile the code.
Is there anyother method by which i can sense the port pin instead of using the build in function.
(eg. in 8051, i can simply write if (INP == 1))

Thanks,
Pravin

[Brian S]

if ( input(PIN_B4) == 1 ) /*Start Sequencing on B4 hi*/
{
.
.
.
}

Cheers!

[Guest]

if( input_state(pin_b4)) "== sequence" isnt necessary . its also boolean true

[PCM programmer]

You didn't post a full test program. It's really important to do that
when you're getting compiler errors. I took your code fragments
and made the test program below. It compiles with no errors with
PCB vs. 3.249.