invalid clock value

[Georg Prinz]

Hi folks,
I use PCWH-compiler V. 3.212 with ICD-U40. Following test program is compiled and loaded correctly and debugger says "Ready MCU at 10MHz":

#include <16f876.h>
#fuses HS,NOLVP,NOWDT,NOPROTECT,DEBUG
#use delay(clock=10000000)
#define led PIN_A5

main
{
while(TRUE)
{
output_low(led);
delay(1ooo);
output_high(led);
delay_ms(1000);
}
}

Stepping through the program goes well until last delay and then it jumps to "'use delay(clock=10000000) saying "Invalid clockvalue from the debugger" and "Ready MCU at 1280MHz". Starting again the program the debugger says "Debugging may not have been enalbled".

Any suggestion?

Thanks in advance.

georg
_________________
dl 2 kp

[Georg Prinz]

Ok folks,

I's running. I checked the hardware carefully and found a hidden resistor.
_________________
dl 2 kp

[Mixy73]

I Have the same problem on my situation, but I din't found any hidden resistor.

Can You are more precise ???

Sorry for my bad english.

Thanks
Marco

[juanma]

CONECTA LOS 5V DEL CONECTOR TARGET, Y OK.
Y LOS DEMAS CLARO.