Programming Interface for TI DSP

[batonie]

I'm about to design a PCB for a project with a TI DSP (TMS320C6720 datasheet).

What is the best method to use as an interface for getting the program onto the DSP? I haven't done this part myself before.

I'll be using CCS v4 and my motherboard has USB 2.0 pots and a parallel port but I'd rather use the USB so that I could keep using whatever cable I need to get in the future.

I'd prefer a low cost solution, I saw some JTAG emulators that cost 100's which is more expensive than I thought would be necessary, however it would be helpful to be able to debug when I'm programming. Thanks

[Ttelmah]

You are on the wrong forum.

This is for Custom Computer Services C for the PIC, not for Texas 'Code Composer Studio'.....

Texas run a Wiki here:
<http://processors.wiki.ti.com/index.php/Category:CCS>

Unfortunately Texas has took to using the name 'CCS' for this, long after CCS (the company).

So you need to join the right forum.

[batonie]