Did anyone else notice this? Shouldn't it go up to VCC (3.3V) ?
I am testing with an oscilloscope which has 10M ohm resistor to GND so it's not because of the 'scope.
I noticed this on PORTE but didn't check other ports.
Ttelmah
Joined: 11 Mar 2010 Posts: 19366
Posted: Sun Sep 14, 2014 7:44 am
No.....
They are not resistors. They are transistor current sources. Read the data sheet. Section 11.3;
"When the internal pull-up is selected, the pin pulls up to
VDD – 1.1V (typical). When the internal pull-down is
selected, the pin pulls down to VSS."
The pull up is also _weak_. 290uA typically. I'd have probably expected more like 2.1v, but your figure is not unreasonable.
PCM programmer
Joined: 06 Sep 2003 Posts: 21708
Posted: Sun Sep 14, 2014 7:48 am
This is a Microchip question. Google for it. Example:
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum