CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ICD-U64 12f675

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
bschriek



Joined: 18 Dec 2007
Posts: 80

View user's profile Send private message Send e-mail

ICD-U64 12f675
PostPosted: Mon May 25, 2009 8:19 am     Reply with quote
A simple question just to be sure:

Can I program a 12F675 with the ICD-U64 while:
#FUSES INTRC_IO, NOMCLR, PROTECT, NOCPD, NOWDT, BROWNOUT, NOPUT
SO: internal oscillator and IO for the NOMCLR-pin is used.

The controller is directly connecteded to the 5-wire programming connector with short wires and has a 47K resistor from the MCLRpin to VDD and there is no noise at the lines.

This question because according the programming specifications ONLY the "VPP-first" mode can be used. Therefore the internal jumper of the ICD-U64 (which feeds the controller with 5V) must be removed.
But now the controller has no 5V power anymore??

Best regards,
Bas
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group