CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
can bus question

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
cooley
Guest
can bus question
PostPosted: Sat Aug 04, 2007 6:07 am     Reply with quote
Hello,
During the initialization phase of the ECAN engine what is happening on the can bus? I have a PIC18F4685 with a 2551 transceiver that is used on a heavy vehicle. This dievice plugs in while the bulldozer is running so the bus is active. occasionally I get an error message from the vehicle when the unit is plugged in. I think there is some disruption of the bus when plugged in. So i guess the question is when does the PIC actually connect to the bus?

Thanks
cooley
Guest
PostPosted: Sat Aug 04, 2007 8:09 am     Reply with quote
sorry it is a MCP2551 that i use for interface
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group