CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
PIC18F2550 doesn't start

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Jody



Joined: 08 Sep 2006
Posts: 182

View user's profile Send private message Send e-mail

PIC18F2550 doesn't start
PostPosted: Mon Jul 02, 2007 7:06 am     Reply with quote
Hello,

I have build an example I found on this forum with the PIC18F2550 and USB..
http://www.ccsinfo.com/forum/viewtopic.php?t=24207&highlight=usb

I want to do it correct so I have made a PCB off it... I programmed it with the code like the example.... But most of the times the device doesn't apear in the Device Manager.... It is not regonised or cannot start...
And one out of ten it works fine......

What is wrong here????

Mine schematic and code:

http://home.casema.nl/elselinde.wisman/

Thanks in advance,

Jody
Ttelmah
Guest
PostPosted: Mon Jul 02, 2007 7:50 am     Reply with quote
Where is your decoupling?.
You show Vusb, being decoupled to Vcc (normally you would decouple to GND), bt then show no decoupling between Vcc, and GND at all....

Best Wishes
Jody



Joined: 08 Sep 2006
Posts: 182

View user's profile Send private message Send e-mail

PostPosted: Mon Jul 02, 2007 8:15 am     Reply with quote
Fixed that...stupid mistake...
but the behavior is the same.... :-(
Ttelmah
Guest
PostPosted: Mon Jul 02, 2007 8:28 am     Reply with quote
Try increasing the capacitor used on Vusb.
There is a known 'oddity' with these chips behaving funnily, which requires a larger capacitor on here to fix. Might be the problem.

Best Wishes
Jody



Joined: 08 Sep 2006
Posts: 182

View user's profile Send private message Send e-mail

PostPosted: Mon Jul 02, 2007 9:13 am     Reply with quote
Oke I will try that,

Thanks I will keep you informed....

Jody
Jody



Joined: 08 Sep 2006
Posts: 182

View user's profile Send private message Send e-mail

PostPosted: Tue Jul 03, 2007 1:22 am     Reply with quote
Fixed it !!!!!!!!!!
Thanks....
It was the decoupling.... there was a lot of noise on the USB power...

Jody
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group