CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
UART Question

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
fuzzy



Joined: 26 Feb 2005
Posts: 64

View user's profile Send private message

UART Question
PostPosted: Mon Feb 26, 2007 11:50 am     Reply with quote
Hi,

I configured my PIC16F88 with hw uart. I need only RX pin and i'd like to use TX pin as Output.

Is it possible to do?

I found some problems, because if i set TX pin as Uart TX my device works fine, but pin RB5 is always 5V.

If i try to exclude pin B5 from uart, compiler compile my code. but device stops working.

Can you help me??

Thanks
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Mon Feb 26, 2007 11:55 am     Reply with quote
Here is a long thread on the topic. See if this helps:
http://www.ccsinfo.com/forum/viewtopic.php?t=28605
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group