CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
PIC16F913 PWM question

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jksor1234



Joined: 18 Jan 2007
Posts: 9

View user's profile Send private message

PIC16F913 PWM question
PostPosted: Mon Jan 22, 2007 11:16 am     Reply with quote
I am using compiler version PCWH 4.020

I am trying to set up the PIC16F913 to output a PWM. When I use the CCS PIC Wizard and set up CCP1 as a PWM, it says the PWM output is on pin C2. However, in the datasheet it says the PWM output is on pin C5. Do I believe the datasheet or the PIC Wizard? My guess is the datasheet.

Thanks
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Mon Jan 22, 2007 5:20 pm     Reply with quote
There's no errata on the 16F913 data sheet at the Microchip site, so
pin RC5 should be correct, as you say.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group