CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
I2C slave pin selection

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jrfeenst



Joined: 12 Nov 2006
Posts: 1

View user's profile Send private message

I2C slave pin selection
PostPosted: Sun Nov 12, 2006 11:26 am     Reply with quote
I would like to setup slave mode for an 18f452 but pin C4 is not available. It is used by an external encoder chip. Is there a way to use the CCS functions to set the pins to something other than C4 and C3?

- Joel Feenstra
jecottrell



Joined: 16 Jan 2005
Posts: 559
Location: Tucson, AZ

View user's profile Send private message

PostPosted: Sun Nov 12, 2006 11:35 am     Reply with quote
I believe you can choose any pin (within reason, none of the odd ones like the open drain ones...) The I2C is bit-banged unless otherwise forced to be hardware.

John
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Sun Nov 12, 2006 2:42 pm     Reply with quote
Here are some previous threads that discuss this:
http://www.ccsinfo.com/forum/viewtopic.php?t=23258
http://www.ccsinfo.com/forum/viewtopic.php?t=23177
http://www.ccsinfo.com/forum/viewtopic.php?t=24250
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group