CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Problems with bank change.

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
carlos.e.carvalho
Guest
Problems with bank change.
PostPosted: Thu Oct 26, 2006 2:18 pm     Reply with quote
I have some problems with my code when it exceeds 50% of ROM. The program stops and I don't know what to do. I am using a PIC16F685 and CCS compiler V4.013
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu Oct 26, 2006 2:21 pm     Reply with quote
Quote:

The program stops and I don't know what to do. I am using a PIC16F685
and CCS compiler V4.013

Download vs. 3.249 and install it.
http://www.ccsinfo.com/compilerupdates.php
carlos.e.carvalho



Joined: 27 Oct 2006
Posts: 2

View user's profile Send private message

Problems with compiler
PostPosted: Fri Oct 27, 2006 12:23 pm     Reply with quote
Hello,

We are testing your compiler with PIC16F685 and PIC16F684 which was given with a 30 days trial after a contact with your comercial department. For this project we need a best compression to use the less expensive PIC.
The compiler is PCM Compiler 4.013.

When we compile our program and it reaches a ROM space higher than 50%, the processor 16F685 stop running. If we hide some lines and the ROM became lower than 50% it run normally.
I tried to use the #SEPARATE command before some functions without success. The Watchdog is disable in configuration bits.

Thanks a lot,
Carlos
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Fri Oct 27, 2006 12:34 pm     Reply with quote
Quote:
after a contact with your comercial department.


From the CCS support page:
Quote:
User Forums
We have setup a message forum set up for CCS C customers to
exchange ideas and thoughts.

Everyone on this forum is a CCS customer or user (except Darren Rook).

You should send an email to CCS tech support. See this page:
http://www.ccsinfo.com/content.php?page=techsupport
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group