CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
hardware power layout

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jjude
Guest
hardware power layout
PostPosted: Tue Sep 12, 2006 5:04 am     Reply with quote
Sorry my bad english!
I need good layout in powerline whit car/boat power.
I regulated 12 volt DC -> 5V DC 7805-regulator, but
when i need "run" my boat DC-motor (viper or waterpump)
my PIC-system "tilt" then i must reset PIC-system.
Can enybody help me?
rnielsen



Joined: 23 Sep 2003
Posts: 852
Location: Utah

View user's profile Send private message

PostPosted: Tue Sep 12, 2006 9:43 am     Reply with quote
Sounds like you might need an inductive/capacitive filter for your power going to the PIC circuit. Also, make sure you have filter capacitors next to each IC in your circuit to help with noise and spikes.
kender



Joined: 09 Aug 2004
Posts: 768
Location: Silicon Valley

View user's profile Send private message Send e-mail Visit poster's website Yahoo Messenger

PostPosted: Tue Sep 12, 2006 11:28 am     Reply with quote
In addition to what RNielsen said, make sure that you have catch diodes for the motors.
If you need to solve the conductive noise problems in the most generic way, galvanically isolate the PIC from the high-noise environments of the motors.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group