CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Need to modify/filter a signal in a CAN bus.. picture inside

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
iso9001



Joined: 02 Dec 2003
Posts: 262

View user's profile Send private message

Need to modify/filter a signal in a CAN bus.. picture inside
PostPosted: Wed Feb 08, 2006 6:01 pm     Reply with quote
Hi,

I've been working with CAN a little bit and come across a problem where like the subject says I need to take a specific couple of signals from a CAN network that is already in place (DeviceNet between two machines) and modify just those signals. Dual wire, High speed. These are big complicated machines so remaking them or reprogramming is not an option.

I am aware that there is the possiblity of an arbitration error occuring if both A and B start at similar times but I think this will be minor.

Any ideas ?
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group