Need source code for interfacing with ENC28J60 Ethernet Chip

overdose_rc · Joined: 18 Oct 2005 Posts: 1 Location: Malaysia

Anyone had a pic source code for interfacing with ENC28J60 Ethernet Chip???

valemike · Guest

Perhaps when you're done writing it, you can post it in the shared code forum.

asmallri · Joined: 12 Aug 2004 Posts: 1634 Location: Perth, Australia

CCS have a port of Microchip stack available for the Realtek controller. To support the ENC controller the MAC.C and MAC.H modules need to be replaced by versions of Microchip's ENC28J60.C and ENC28J60.H modules.

I have written my own CCS equivalent of the ENC28J60 MAC drivers but it in not in the same format as Microchip's because I use my own stack. However it would be possible to take the code and put it in the required format. Unfortunately I don't have the time at the moment to do this.

When do you need it?
_________________
Regards, Andrew

http://www.brushelectronics.com/software
Home of Ethernet, SD card and Encrypted Serial Bootloaders for PICs!!