CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Low voltage programming

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
greg shipley
Guest
Low voltage programming
PostPosted: Wed Sep 28, 2005 11:47 am     Reply with quote
Looking for an in circuit programming solution for my 16LC771.
ICD does not work becuase of the 13V on pin 1 right?
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Wed Sep 28, 2005 1:08 pm     Reply with quote
There is no low voltage programming with that PIC. You must use
high voltage programming. You isolate MCLR from Vdd with a resistor.
See this thread and the links within it:
http://www.ccsinfo.com/forum/viewtopic.php?t=19643
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group