CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Using a software and hardware Uart

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
wintermute
Guest
Using a software and hardware Uart
PostPosted: Sat Sep 10, 2005 12:00 am     Reply with quote
I'm a little bit confused about how to setup a software uart that
won't interfere with the hardware uart. Setting up the hardware
uart for my P18f452 was very straight-forward. But, How would
I, for example setup rs232 out for PIN_A5? For instance, when
doing a printf, how would I specify the SW as opposed to the
HW uart? The PCW manual isn't exactly clear and google is
returning much more complicated results then I need, I.e.
rs232 SW interupts. If anyone could point out some example
code out there on the net for me I'd be very grateful.

Sorry for the newbie question, thanks in advance for any
replies.
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Sat Sep 10, 2005 1:53 am     Reply with quote
Quote:
For instance, when doing a printf, how would I specify the SW as
opposed to the HW uart ?

See this thread on RS-232 streams:
http://www.ccsinfo.com/forum/viewtopic.php?t=19515
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group