Work debugging and without not

bertronicom · Posted: Mon Apr 25, 2005 5:35 am

CCS v3.223
ICD v2.29

I have working my program with debug but when I program with ICD the pic don't work.

#use delay(clock=4000000)
#fuses NOWDT,WDT128,XT, NOPROTECT, NOOSCSEN, BROWNOUT, BORV20, NOPUT, STVREN, NODEBUG, LVP, NOWRT, NOWRTD, NOWRTB, NOWRTC, NOCPD, NOCPB, NOEBTR, NOEBTRB

//#device ICD=true

Guest · Posted: Mon Apr 25, 2005 6:56 am

Can you post your fuse line for debugging.

drolleman · Guest

Make sure you set the the debuging off and dont program with debug but program mode.

Mark · Joined: 07 Sep 2003 Posts: 2838 Location: Atlanta, GA

And remember to remove the programming/debugging header. It might be keeping the device in reset. There is a button on the programming toolbar in MPLAB to release from reset if you don't want to disconnect the programming header.

treitmey · Joined: 23 Jan 2004 Posts: 1094 Location: Appleton,WI USA

And remember if your doing serial com to you PC. You may need a ground wire connecting the two. If you don't have a common reference, serial comm might not work well. You see with the ICD in place, it is providing that common gound. When you remove ICD the serial comm stops working.