CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
timer0 16 bit mode

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
david
Guest
timer0 16 bit mode
PostPosted: Tue Nov 02, 2004 9:20 am     Reply with quote
I can't get timer0 to use the entire 16 bits. TO8BIT in T0CON is 0 but the timer rolls over at FF. I used the setup_timer_0 function to set the prescaler and clock source. If I use the RTCC_8_BIT to set it up for 8 bit mode then the interrupt works. If I let it default to 16 bit mode the counter justs rolls over at FF with no interrupt occuring. The device I'm targetting does have a 16bit timer0.
future



Joined: 14 May 2004
Posts: 330

View user's profile Send private message

PostPosted: Tue Nov 02, 2004 10:37 am     Reply with quote
Are you simulating the code in mplab?

If yes, this is a known bug.
david
Guest
Yes simulating in MPLAB
PostPosted: Tue Nov 02, 2004 11:32 am     Reply with quote
Thanks,
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group