CCS :: View topic - 2 PWM in 16F876???

CCS C Software and Maintenance Offers

FAQ

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

2 PWM in 16F876???

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

verba

Joined: 17 Aug 2004
Posts: 12

2 PWM in 16F876???

Posted: Tue Aug 17, 2004 12:16 am

Reply with quote

In the manual and in the datasheet, specifies that 16f876 has 2 PWM (C1 and C2).
I put this in the CCS:

Code:

setup_timer_2(T2_DIV_BY_1,9,1); //4Mhz, 100 Khz PWM timer
output_high(PIN_C1); //Init Pin C1 as output
output_high(PIN_C2); //Init Pin C2 as output
setup_ccp1(CCP_PWM); //Mode PWM CPP1
setup_ccp2(CCP_PWM); //Mode PWM CPP2
set_pwm1_duty(10); //Init PWM1 (10=100%..0=0%)
set_pwm2_duty(10); //Init PWM2 (10=100%..0=0%)

Ok, this doesn´t work. Only works the PWM2 (C1) , the PWM1 (C2) is always 0.
Why? What´s is wrong? I can´t configurate the two PWM at same time?
Thank you very much

Kenny

Joined: 07 Sep 2003
Posts: 173
Location: Australia


Posted: Tue Aug 17, 2004 1:31 am

It works for me (compiler version 3.188). Your arithmetic is fine. I didn't change anything in your code. Also I tested it by sweeping the values from 0 to 10 and back to 0, all OK.

verba

Joined: 17 Aug 2004
Posts: 12

Not for me
Posted: Tue Aug 17, 2004 3:34 am

I have 3.155 Is it possible that my version doesn´t compile correctly the PWM ?

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB © 2001, 2005 phpBB Group