CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
.cof file problem again

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
water_r
Guest
.cof file problem again
PostPosted: Tue Feb 17, 2004 7:11 pm     Reply with quote
hi, all,
I am using MPLAB 6.40 and PCW 1.094v. Each time I clicked "compile", one small window always came out, stating "Failed to load xx.cof file".
This problem has been posted before. Do anyone know the solution? Thanks in advance.
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue Feb 17, 2004 9:35 pm     Reply with quote
Quote:
Each time I clicked "compile", one small window always
came out, stating "Failed to load xx.cof file".


This thread gives two possible solutions.
I had this problem and fixed it by the 2nd one.
ie., Remove printf statements until the error goes away.
http://www.ccsinfo.com/forum/viewtopic.php?t=6292&highlight=failed+load+cof
water_river



Joined: 17 Feb 2004
Posts: 16

View user's profile Send private message

failed to load .cod file instead??
PostPosted: Tue Feb 17, 2004 10:53 pm     Reply with quote
When I removed the "printf" statements, it still failed to load the .cof file.
But as I right clicked the c file and changed the Debug Option to "none", it became "failed to load the .cod file" instead ???
BTW, My compiler is PCW3.094
tmach



Joined: 20 Dec 2003
Posts: 14

View user's profile Send private message

Re: failed to load .cod file instead??
PostPosted: Wed Feb 18, 2004 6:55 pm     Reply with quote
I had a similar bad experience last week. This problem started when I installed MPLAB 6.40 without removing MPLAB 6.1 that was on my syatem. Then I had to remove all previous installations and reinstall MPLAB 6.40 and the problem disappeared.
Hope this works out for our case.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group