all ways to change pin output

[nuclear__]

Hi there, probably the truth is out there but I cannot find it. A simple question.
Other that output_high(pin) what other way exist to set pins in boolean way?
For example how can I set a pin x high when pin y is low ( both outputs)?
Or to say that if pins x ,y (inputs) are both high,set w high too.

[temtronic]

1) you can read a port and use a 'mask' to set/reset individual pins when you write to that port.

2) you need to read the port, decide if x is high, then set y. similar proceedure to above

3) simple combination logic. Any 'C101' book should explain it

the CCS manual may have examples, the examples folder probably does and of course Google can find anything !

As there are several ways to do all of this, how you do it depends on several factors. PIC type, speed reqd, available memory,etc.

[PCM programmer]

From the CCS manual:

[nuclear__]

[temtronic]

output_bit(pin_a2, a);
or maybe

output_bit(pin_a2, input_state(pin_a1));

I can't try. not on compiler computer...

edit...

[nuclear__]

Thank you both guys.