CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
enc28j60 module MAC

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
biomed12



Joined: 05 Feb 2016
Posts: 33

View user's profile Send private message

enc28j60 module MAC
PostPosted: Wed Aug 24, 2016 3:30 pm     Reply with quote
Hello everyone,

I have a trouble with enc28j60. I bought a module and created circuit briefly.
Neither in udp project nor in http server project, pic doesn't connect to my router. I think that is relevant with MAC address of module. I read the datasheet and it says "you can write in your software 00:04:A3:00:00:00 and pic will detect automatically and will connect your network. Briefly, module didn't get an IP address from router... Is there anyone had same issue or had any idea or experiment?

Thanks...

EDIT: I have shooted trouble. I tried to run encxxx with 3.3 operating voltage and my server is running now.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group