output_high2 & output_low2 is now available

[z3ngew]

Hello everyone,
I have wrote a Generic method that will allow CCS users to output_high or output_low two pins that belong to the same port at the same time, for example; PIN_A0, PINA7 without changing its previous state.

the down side of this method is that, when you are using a device with small RAM memory, you will feel like if you RAM has reached over 50%.
but in large RAM memory devices this like 18F452 or example, this should not be a problem

and also there is a manual control the user must make in case your device doesn't have PORT_X ( X is the name of the port).
the user must know the unsupported port name, and then comment the following line concerned with the same port

[byakuya]

Para mi con esto basta amigo


#INCLUDE <18F4550.h>
#FUSES PLL5, CPUDIV1, USBDIV, HSPLL, NOFCMEN, NOWDT, NOPROTECT, NOIESO, PUT
#FUSES NOBROWNOUT, VREGEN, NOWDT, NOSTVREN, NOLVP, NODEBUG, NOPROTECT, NOCPB
#FUSES NOXINST, NOWRT, NOEBTRB, MCLR, NOLPT1OSC, NOPBADEN, STVREN, NODEBUG
#USE DELAY(CLOCK = 48MHZ)

INT8 COLUMNA[8]={PIN_D0,PIN_D1,PIN_D2,PIN_D3,PIN_D4,PIN_D5,PIN_D6,PIN_D7};


VOID MAIN (VOID)
{
FOR(;;)
{
FOR(INT8 I=0; I<7; I++) {
OUTPUT_HIGH(COLUMNA[I]);
DELAY_MS(500);
OUTPUT_LOW(COLUMNA[I]);
DELAY_MS(500);
}
}
}
_________________
Cuando venga la inspiracion que me encuentre trabajando