Problems with PWM output 4 on PIC16F1827 pin RA4

[AJEllisuk]

Hi,

I'm working on a project to generate PWM output 4 on RA4.

The problem I have is that when I turn off PWM4 with:

[Ttelmah]

Turning the CCP 'off' disables the peripheral. So the duty cycle no longer applies. Remember the duty cycle needs to be a 'long'. So simply:

set_pwm4_duty(0L);

should set the output low.

The 'priority' on this pin, is:

SR latch, PWM, T0CKI, C2OUT, RA4

So when you disable the PWM, unless T0 is set to use an internal clock, and comparator two is disabled, these will both have priority 'over' the simple pin function, stopping it from working.....

[AJEllisuk]

Hi Ttelmah

Thank you for your reply; my problem is now resolved.

Kind regards

Andrew