CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Send a serial Break command

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
macgyver



Joined: 24 Aug 2005
Posts: 12

View user's profile Send private message

Send a serial Break command
PostPosted: Tue May 26, 2009 10:31 am     Reply with quote
anyone know how to send a serial Break command in CCS?

I can do it by tying C5 to C6 pulling C5 low then floating it again but was wondering if there is a way to toggle C6 while it's in use by the UART
using a 16f877
20meg
max232

Thanks.
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue May 26, 2009 11:32 am     Reply with quote
See Ttelmah's proposed solution in this thread. Note the addtional
comments after it, which modify it a little.
http://www.ccsinfo.com/forum/viewtopic.php?t=20488
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group