CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
USART - changing to odd parity

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
mshearer



Joined: 12 Jan 2009
Posts: 33

View user's profile Send private message

USART - changing to odd parity
PostPosted: Mon Jan 12, 2009 4:38 am     Reply with quote
Hi, I have a UART connection with working transmit/recieve.

However i need to change the parity to odd. Should this be a simple case of changing
Code:
#use rs232(baud=9600, xmit=PIN_C6, rcv=PIN_C7, parity=N, bits=8

to
Code:
#use rs232(baud=9600, xmit=PIN_C6, rcv=PIN_C7, parity=O, bits=8


then adjusting the settings in whatever terminal application?

thanks for any help given,

matt
mshearer



Joined: 12 Jan 2009
Posts: 33

View user's profile Send private message

PostPosted: Mon Jan 12, 2009 5:19 am     Reply with quote
not to worry, seem to have it fixed.
I didn't have the TX9 and RX9 bits enabled for 9th bit use.

matt
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group