I had a question about the internal touch module of pic 16f723a.
Do internal pins need the external pull ups ?
There was nothing obvious about it in the datasheet.
I use 4 spring as antenna for pcb pads.
And they go straight to the micro without anything. Is this method correct?
And then I set them from within the Code.
Joined: 11 Mar 2010 Posts: 18068
Posted: Sun May 01, 2022 2:41 am
You most definitely do not want the pullups enabled on touch pins. Touch
is a capacitive sensing technology, not resistive.
The touch behaviour is dependant on how the sense wires and the ground
changes. Very dependent on how the ground is laid out.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum