Using a ICDU40 with a 12F675 - Wiring Diagram

[alm1006]

I'm thinking of using a small 8 pin pic for basic timing signals.
I'd like to use the debugging and programing featured claimed supported
on the ICDU40 site - though none of the pins other than MCLR match, V+
In other words:
ICD Pin 1 = Any unused I/O pins on target pic - RB3 by default
2 = RB6 - PGC
3 = RB7 - PGD
4 = Ground - not a problem
5 = V+ - not a problem either
6 = MCLR pulled up through a 47K resistor - easy enough

Can anyone suggest where to start or how to correlate what pins is what on the 12F675 OR suggest another low cost part...

What would we do without these sites!!

Best wishes and happy picin ;-)
Albert

[treitmey]

Programming is possible, but debug is more difficult.
spec page 67