CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
CCS Bootloader and the PIC18F87J11

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Xien
Guest
CCS Bootloader and the PIC18F87J11
PostPosted: Fri Dec 07, 2007 6:22 pm     Reply with quote
I have been attempting to get the CCS bootloader to work on my PIC18F87J11 for a few days now with no luck. Sad We had this code working on the CCS development board (PIC18F8722 I think), but opted to go with the 87J11 for the final design.

I have modified the CCS code to account for the config bytes at the top of memory by adjusting this line:

Code:
//#define LOADER_END      getenv("PROGRAM_MEMORY")-1  //original
#define LOADER_END      getenv("PROGRAM_MEMORY")-9


The bootloader runs, programs memory, but when restarting the device ex_bootload will not start. I have verified that the .hex file is transfered over successfully and uncorrupted, so there must be some aspect of the 87J11 that I am not accounting for. Any suggestions are welcome.
xien
Guest
PostPosted: Fri Dec 07, 2007 6:28 pm     Reply with quote
Forgot this info: Compiler Version PCH 4.062 in through PCW
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group