CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support

How to debugger to DLP-245PL board.

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
Haiping
Guest







How to debugger to DLP-245PL board.
PostPosted: Wed Aug 02, 2006 7:15 am     Reply with quote

I bought the USB Development Kit with CCS C compiler and ICD-U40. Now I try to debug my C code into DLP-245PL-G board with PIC18LF8722 microchip. There is only USB connector in DLP-245PL-G board. But, that is modular cable connector in target side of ICD-U40.
How can I connect the DLP-245PL-G board and ICD-U40/programmer to embed my code into microchip?

Thank you so much
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group