CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
How to make my own prototyping board for ICU-U40?

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
o_wan
Guest
How to make my own prototyping board for ICU-U40?
PostPosted: Fri Oct 21, 2005 12:46 pm     Reply with quote
hi all,

Any links or schematics or how-tos for make my own prototyping board for ICU-U40?

I've checked out that FAQ on CCS website, but it doesn't work.

Cheers,
Annie
kender



Joined: 09 Aug 2004
Posts: 768
Location: Silicon Valley

View user's profile Send private message Send e-mail Visit poster's website Yahoo Messenger

PostPosted: Sat Oct 22, 2005 4:19 pm     Reply with quote
Way to go, man! Don't waste yu time and money on canned prototyping boards.

Are you looking to make a PCB? Are you going to use the surface-mount or through-hole components?

If you want to make something very quickly and without engineering risk, you can put together a breadboard. To connect the ICD-U, get a female RJ11 connector with pigtail wires (DigiKey H9016-ND, Jameco 124038 cheaper) and plug it into your breadboard.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group