CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ICD-U40

 
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go
View previous topic :: View next topic  
Author Message
newpic



Joined: 09 Aug 2005
Posts: 32

View user's profile Send private message

ICD-U40
PostPosted: Mon Aug 22, 2005 8:52 am     Reply with quote
I have problem using the ICD-40 as programmer.
Anybody has solution??
Please help...

The code is written in Hi-Tech C. After I compiled, there is a .hex file.
I used the CCS ICD-40 and its GUI software to program it into the CHIP
and it will never work. It seemed program OK, but when the board will
never work.
rwyoung



Joined: 12 Nov 2003
Posts: 563
Location: Lawrence, KS USA

View user's profile Send private message Send e-mail

PostPosted: Mon Aug 22, 2005 10:13 am     Reply with quote
Check the fuses being programmed. Things like oscillator type, power-up timer, brownout etc.

Also fuses and address 0 as related to the debugger.

Can you read back the program from the PIC. I don't mean the verify that occurs right after programming. I mean manually reading back and verifying.
_________________
Rob Young
The Screw-Up Fairy may just visit you but he has crashed on my couch for the last month!
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> CCS ICD / Mach X / Load-n-Go All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group