CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Pull Up on PORTa

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
vtrx



Joined: 11 Oct 2017
Posts: 142

View user's profile Send private message

Pull Up on PORTa
PostPosted: Tue Aug 20, 2019 7:58 pm     Reply with quote
If i use a 47K resistor as pull up on PORTa will the digital input be unstable?
I intend to use ADC or Digital Input on the same pin, selected by software.
Ttelmah



Joined: 11 Mar 2010
Posts: 19631

View user's profile Send private message

PostPosted: Wed Aug 21, 2019 12:35 am     Reply with quote
Depends totally on your environment.

47K is adequate to 'pull up' a digital signal that is only using relatively low
signal capacitance (so a short line), and not requiring fast slew rates (so
not trying to send fast edges). Remember as well that the analog signal
(when enabled), needs to meet the ADC impedance requirements, and will
be driving into this pull up. How do you visualise switching these signals?.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group