CCS :: View topic - dsPic30Fxxxx

FAQ

Forum Help

Official CCS Support

Profile Log in to check your private messages Log in

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

dsPic30Fxxxx

CCS Forum Index -> General CCS C Discussion

View previous topic :: View next topic

Author

Message

kmp84

Joined: 02 Feb 2010
Posts: 345

dsPic30Fxxxx

Posted: Tue Mar 24, 2015 8:44 am

Hello all!

I have some question about dsPic:

1. Can't connect to dsPic30F3014 using ICD-U64-Software ver.5.007, Firmware ver. 3.04. I'm using CCS C PCD 5.036 version. With Microchip ICD2 no problem. I use 47k to MCLR pin and vcc, PGD, PGC, Vcc=5v, GND.
What is the problem?

2. When I try to debug target with this example:

Code:

#include <30F4013.h>
#device ICD=TRUE
#fuses NOWDT
#use delay(crystal=10M)
#use rs232(BAUD=9600,UART1A)

float32 y = 123.3546;

void main(void) {

printf("Hello at Main()\n\r");

for(;;)
{
printf("Hello dspic30Fxxxx... \n\r");
printf("y= %f\n\r",y);
delay_ms(1000);
}
}

with ccs c ver. 4.140 and ICD2 target run and print float variable, but ccs c ver 5.036 when reach

Code:

printf("y= %f\n\r",y);

break and go to start point.

3. My general question is : CCS C Compiler + ICD U64 (especially ver.5) maybe is not true way for develop project with dspic ??

Thanks before.

Display posts from previous:

	CCS Forum Index -> General CCS C Discussion	All times are GMT - 6 Hours
Page 1 of 1

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum