CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
dspic33 and ICD2

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
newCCSUser



Joined: 25 Aug 2013
Posts: 12

View user's profile Send private message

dspic33 and ICD2
PostPosted: Wed Jul 09, 2014 2:03 am     Reply with quote
Hi.

Is it possible to burn/program/debug dspic33 with ICD2 ?
I use it for last 5 years at least and there was some topic where someone claims it's possible. Didn't check device support list but i was planning on using it with mplabx on linux.
Ttelmah



Joined: 11 Mar 2010
Posts: 19520

View user's profile Send private message

PostPosted: Thu Jul 10, 2014 3:11 am     Reply with quote
Depends on the chip.

There should be a 'readme for ICD2' in the MPLAB installation, This lists the supported devices.

Look at:
<http://www.edaboard.com/thread24167.html>

Some chips do get complex. Some parts that can run at 3.3v, cannot program at this voltage (thankfully not many). This is a 'read the data sheet' problem.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group