CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ICD-64U and TX2=PGC

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
hmmpic



Joined: 09 Mar 2010
Posts: 314
Location: Denmark

View user's profile Send private message

ICD-64U and TX2=PGC
PostPosted: Mon Mar 10, 2014 9:20 am     Reply with quote
Hi

Now I used some hour finding UART2 is (not) working?

The problem is ICD-64U is connected to PGD & PGC. After debugging or programming it hold PGC -> TX2 (same pin om 18F26K22) = L. Is that normal?
When removing ICD-64U all is working. I think it is not nice design to have low impedance load or holding pin L.
Ttelmah



Joined: 11 Mar 2010
Posts: 19515

View user's profile Send private message

PostPosted: Mon Mar 10, 2014 9:36 am     Reply with quote
First general comment, all unused inputs should be held high or low....
Better design than leaving them floating.

The PGC pin _must_ be held low, if the chip is programmed in 'debug' mode, or it won't run reliably.This is why the ICD does this.
hmmpic



Joined: 09 Mar 2010
Posts: 314
Location: Denmark

View user's profile Send private message

PostPosted: Mon Mar 10, 2014 10:22 am     Reply with quote
Hi

It is the same problem in clean programming mode:-(
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group