CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
ds30 Bootloader and CCS

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Lykos1986



Joined: 26 Nov 2005
Posts: 68

View user's profile Send private message

ds30 Bootloader and CCS
PostPosted: Sat Jul 06, 2013 11:36 am     Reply with quote
Once again a new question from me!

I was trying the ds30 bootloader and so far I managed to successfully load a few hex files with it using serial port and not my ICD2! It seems that I can load files with the ds30 GUI only when I first write the bootloader at the PIC16F877A. After that it is not working...

After reading the bootloader manual I can see that I have to place at address 0x00 (green arrow at the picture below) a goto statement. How I can do that? I am using MpLab...

And here is a screenshot from the ds30 manual that specifies this step:


Many many thanks in advance!
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group