CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com

read protect question

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
javi.ar



Joined: 17 Feb 2006
Posts: 59
Location: Argentina

View user's profile Send private message Send e-mail Visit poster's website MSN Messenger

read protect question
PostPosted: Thu May 31, 2012 1:46 pm     Reply with quote

I have one simple question, if I activate a code protect from read, will I be able to write again and again ? and one more, in the following writings will be still active the read protected even if I remove the fuse ? in 18f46K22 CCS ver 4.120. thanks a lot.
matteo



Joined: 31 May 2012
Posts: 5

View user's profile Send private message

PostPosted: Thu May 31, 2012 2:07 pm     Reply with quote

A bulk erase should reset the protection bits but people often have issues reprogramming.
temtronic



Joined: 01 Jul 2010
Posts: 9163
Location: Greensville,Ontario

View user's profile Send private message

PostPosted: Thu May 31, 2012 2:26 pm     Reply with quote

I've never had any issues reprogramming any of my PICs in the past 25 years of using them(1000s of PICs). I do still use my Picstart Plus programmers.Any issues might be caused by 3rd party or homemade programmers.
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Thu May 31, 2012 2:32 pm     Reply with quote

He means the isse where you can only erase code protection config
bits with bulk erase, and bulk erase only works at +5v. So if you set
code protection on a +3.3v board you will have a problem.
Example:
http://www.ccsinfo.com/forum/viewtopic.php?t=20090
and
http://www.ccsinfo.com/forum/viewtopic.php?t=20620
temtronic



Joined: 01 Jul 2010
Posts: 9163
Location: Greensville,Ontario

View user's profile Send private message

PostPosted: Thu May 31, 2012 7:57 pm     Reply with quote

hmm..I'm still stuck in the 5 volt only mode...comes from my 7400 series days..so I never think of the 3 volt supply issues...
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group