CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Motor pwm with dspic30f4011

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
IEEE_az



Joined: 02 Dec 2011
Posts: 1
Location: BOGOTA

View user's profile Send private message MSN Messenger

Motor pwm with dspic30f4011
PostPosted: Fri Dec 02, 2011 8:17 pm     Reply with quote
Hi everybody, I want to work with the pwm motor module in my dspic30f4011. I use instructions like setup_motor_pwm(), set_motor_unit(), and set_motor_pwm_duty(), but always those pins are at 0v (RE0, RE1, RE2, RE3, RE4, RE5). Maybe someone knows how I should set the module and give me a little help. Thanks, bye.
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group