CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
About ICD-U40 programmer

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
jimj



Joined: 23 Jan 2011
Posts: 1

View user's profile Send private message

About ICD-U40 programmer
PostPosted: Mon Jan 24, 2011 12:17 am     Reply with quote
Hi,
I have a ICD-U40 (Rev 5) programmer and my target chip is pic18f66k22. The programmer software is CCS Device Programmer (V4.028) and the voltage of the target board is 5V. The connection of the programmer and the PC is no problem. My question is the programmer can't read the target chip. The target information shows the voltage of the pic18f66k22 is 3v only, but the datasheet of this chip shows its operating voltage range is 1.8v-5.5v. The diagnostics shows it can't read device ID. I used the DVM to check it. The PGD and the PGC is no problem but the Vdd of the MCLR is only 4v. I don't know why, whether the programmer don't support this chip. I am waiting for your help. Thank you!

jim
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group