CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
18F452 RS232 Stop Bit ?!

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
3l3ctr0



Joined: 18 Mar 2010
Posts: 5

View user's profile Send private message

18F452 RS232 Stop Bit ?!
PostPosted: Thu May 20, 2010 10:40 am     Reply with quote
Hi Dear Friends!

I have a problem with my RF module.
I can send data from PC to another PC, but I cannot do it with my PIC.

I connected to PIC with my RF module by using 2k and 3k resistor and I take 3v data voltage for my module. And our module needs 1 stop bit for serial comm.

**So how can I use stop bit 1 with 18f 452?

**How can I convert 3v to 5v data voltage level?

**Also is our circuit ok for converting 5v to 3v?
Ttelmah



Joined: 11 Mar 2010
Posts: 19328

View user's profile Send private message

PostPosted: Thu May 20, 2010 2:27 pm     Reply with quote
The PIC UART develops one stop bit 'as standard'.
It is impossible to tell whether your resistors would give 5v to 3v conversion, without 'seeing' the circuit, and without details of the impedance being driven, etc. etc...

Best Wishes
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group