CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
want to use eccp in 16f616....

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
prabodh



Joined: 07 Mar 2010
Posts: 2
Location: india

View user's profile Send private message

want to use eccp in 16f616....
PostPosted: Sun Mar 07, 2010 12:51 pm     Reply with quote
Hello everybody, I am new to CCS and to forum too. I want help in
generating two pwm of around 32khz which are complement to each
other with an dead band of 2usec. How could I do this? Is there any
way to work out? Plz help me for above said in CCS...
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Sun Mar 07, 2010 1:29 pm     Reply with quote
Look in the PWM section of the 16F616 data sheet and find a diagram
that shows the waveforms that you want. Then post the "Figure" number
of the diagram.
prabodh



Joined: 07 Mar 2010
Posts: 2
Location: india

View user's profile Send private message

PostPosted: Mon Mar 08, 2010 4:53 am     Reply with quote
Hello PCM programmer,
I am trying to drive the ECCP module of 16F616 in half bridge mode at 50% duty cycle with 32Khz frequency. Also I need a deadband of 1-2uSec in between two signals at P1A and P1B
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group