CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
USB Connection problem

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
Neddie
Guest
USB Connection problem
PostPosted: Fri Oct 23, 2009 4:24 am     Reply with quote
Hi to all.
I have a problem getting my board to connect to the pc via usb.
I'm using the CCS cdc driver.
If I plug the board into the pc (getting the boards power from the usb port)
the pc does not recognize the usb device. If I then reset the processor,
without disconnecting the board, the pc sees the usb device fine.
What could be causing this problem. I've tried putting a 3second delay as
the first thing in my code , before and usb code runs, with no difference.
Any ideas?
Cheers
Rob
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group