CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to support@ccsinfo.com
Using analog input pins on the pic

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
lyndia



Joined: 19 Jul 2009
Posts: 5

View user's profile Send private message

Using analog input pins on the pic
PostPosted: Fri Jul 24, 2009 9:36 am     Reply with quote
Hi,

Will I be able to use RA0/AN0 for digital output, while using RA1/AN1 for analog input?

The A/D Port Configuration Control bits (PCFG3:0) enable analog input in such a way:
AN0
AN0, AN1
AN0, AN1, AN2
...

I just want to confirm that setting RA0 as output will not be affected by these configuration bits.

Thanks
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Fri Jul 24, 2009 11:14 am     Reply with quote
See this explanation of dual use of digital/analog i/o pins by Ttelmah:
http://www.ccsinfo.com/forum/viewtopic.php?t=38205&start=6
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group