CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
best practices for LCD FLEX etc display in Nibble mode

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
asmboy



Joined: 20 Nov 2007
Posts: 2128
Location: albany ny

View user's profile Send private message AIM Address

best practices for LCD FLEX etc display in Nibble mode
PostPosted: Tue May 12, 2009 12:17 pm     Reply with quote
any comments on best practice for dealing with
D0-3 ( unused lines ) on LCD modules when used in 4bit Nibble mode ?

Ground 'em or or let em float ? ( other ??)
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Tue May 12, 2009 12:29 pm     Reply with quote
Look at the schematic on the bottom of page 54 in the HD44780 data
sheet. The data bus pins have a weak pull-up on them. You don't have
to do anything with the unused pins. Leave them unconnected.
http://www.melabs.com/downloads/hd44780u.pdf
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group