CCS C Software and Maintenance Offers
FAQFAQ   FAQForum Help   FAQOfficial CCS Support   SearchSearch  RegisterRegister 

ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

CCS does not monitor this forum on a regular basis.

Please do not post bug reports on this forum. Send them to CCS Technical Support
Need help in the CAN Baud rate settings

 
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion
View previous topic :: View next topic  
Author Message
harishchincholi



Joined: 06 May 2009
Posts: 1

View user's profile Send private message Send e-mail Yahoo Messenger

Need help in the CAN Baud rate settings
PostPosted: Wed May 06, 2009 1:31 am     Reply with quote
Hi,

This is Harish Chincholi, Very Happy new to this forum, I am currently working on CAN protocols. I have been using PIC18F4580 with MCP2551 for my project. I am stuck with a problem, When i am trying to send data from one board to another, The transmission takes place but at receiver end there comes garbage value, I guess its due to phase segment and baud rate settings needs to be corrected. Can anyone help me with this problem. Sad I am using 8Mhz crystal.
_________________
Thanks & Regards,
Harish Chincholi
PCM programmer



Joined: 06 Sep 2003
Posts: 21708

View user's profile Send private message

PostPosted: Wed May 06, 2009 1:37 am     Reply with quote
See this post:
http://www.ccsinfo.com/forum/viewtopic.php?t=22138&start=7
Display posts from previous:   
Post new topic   Reply to topic    CCS Forum Index -> General CCS C Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group