Enhanced PWM and CCP modes on PIC18F8722

[abq_guy]

Hello All,

I am using the ECCP2 and CCP4 and CCP5 mode on the PIC18F8722. I set the ECCP2 mode in full bridge configuration. I wanted to set the three PWM channels on three different frequencies with three different duty cycles.

I can easily set the duty cycle to be different for each PWM channel. How do I set different PWM frequencies for each of them, since all of them are referencing Timer2 Prescaler and PR2 register for the frequency.

Is there any way I can set different frequencies for ECCP2, CCP4 and CCP5. Also I might have to change their frequencies and duty cycles on the fly

Thanks,

abq_guy